|
|
|
National Stock Number:
5935-00-226-7765
Federal Supply Class:
5935
National Item Identification Number:
002267765
Description:
DUMMY CONNECTOR,RECEPTACLE
Detail:
An item specifically designed to mate with a plug connector to perform one or more special functions, such as to support a plug connector when not in use, short contacts, or open or close electrical circuits, in or on another connector. It does not have provisions for attaching a wire, cable, or contact. It is designed to mount on a panel, bulkhead, wall, or chassis. It does not include connector shells which are merely used to position a plug connector on a panel.
|
Manufacturer Information:
| MS3115-14B | 96906 | MILITARY STANDARDS PROMULGATED BY MILITARY DEPARTMENTS UNDER AUTHORITY OF DEFENSE STANDARDIZATION MANUAL 4120 3-M |
|
Techincal Specification:
| DISTANCE FROM MOUNTING SHOULDER TO FRONT FACE | 0.462 INCHES MINIMUM AND 0.493 INCHES MAXIMUM | | CENTER TO CENTER DISTANCE BETWEEN MOUNTING FACILITIES PARALLEL TO HEIGHT | 1.031 INCHES NOMINAL | | CONNECTOR LOCKING METHOD | BAYONET PIN | | DISTANCE BETWEEN CENTERLINES OF MOUNTING FACILITIES PARALLEL TO BODY WIDTH | 1.031 INCHES NOMINAL | | ENVIRONMENTAL PROTECTION | MOISTURE RESISTANT AND SALT WATER RESISTANT AND VIBRATION RESISTANT | | INSERT MATERIAL | RUBBER SYNTHETIC SINGLE MATING END | | OVERALL HEIGHT | 1.360 INCHES MAXIMUM | | OVERALL LENGTH | 0.524 INCHES NOMINAL | | OVERALL WIDTH | 1.360 INCHES MAXIMUM | | MATING END QUANTITY | 1 | | SHELL MATERIAL | ALUMINUM ALLOY | | SHELL SURFACE TREATMENT DOCUMENT AND CLASSIFICATION | QQ-P-416,TY 2,CL 3 FED SPEC SINGLE TREATMENT RESPONSE | | SHELL SURFACE TREATMENT | CADMIUM | | SHELL TYPE | SOLID | | TEST DATA DOCUMENT | 81349-MIL-C-26482 SPECIFICATION (INCLUDES ENGINEERING TYPE BULLETINS, BROCHURES,ETC., THAT REFLECT SPECIFICATION TYPE DATA IN SPECIFICATION FORMAT; EXCLUDES COMMERCIAL CATALOGS, INDUSTRY DIRECTORIES, AND SIMILAR TRADE PUBLICATIONS, REFLECTING GENERAL TYPE DATA ON CERTAIN ENVIRONMENTAL AND PERFORMANCE REQUIREMENTS AND TEST CONDITIONS THAT ARE SHOWN AS "TYPICAL", "AVERAGE", "NOMINAL", ETC.). | | UNTHREADED MOUNTING HOLE DIAMETER | 0.115 INCHES MINIMUM AND 0.125 INCHES MAXIMUM |
|
|